Mini Hot Water Heater for Kitchen and Bathroom - Electric Tankless Under Sink Tap

Features: Automatic power off when leakage. LCD digital temperature display. Mini body, energy saving, and high efficiency. Safe and intelligent, no water flow stops heating. Stainless construction, durable, elegant and fashionable. Constant temperature maintains the optimal water temperature for you. It heats water as the water passes thru the unit, instant heating, so you can use the hot water as you like. Easy to install under the bathroom or kitchen sink for shower, washing dishes, food, clothes and other functions. Safe heater, electricity saving, water saving, no pollution, no exhaust gas. Various protections: Leakage protection, IPX4 waterproof, Dry heating protection, Water-electricity isolation, Auto power off at inactive state, Over-temperature automatic power off. Specification: Installation method: hanging Material: ABS Color: White Rated voltage: 220V Rated power: 50Hz Rated power: 3000W Temperature peak: 20-50 Product size: 19.5*11.6*7cm Note: the temperature is controlled by the size of the water flow. The temperature is low when the water flow is large, and the temperature is high when the water flow is small. You can set the degrees Fahrenheit and degrees Celsius mode switch, under the startup state, long press the power button for more than 6 seconds, you can switch modes Package Included: 1 × Water Heater About mini water heater installation and use: Installation environment requirements: kitchen, toilet, toilet, shower room, wire requirements greater than 2.5 square; Circuit breaker switches greater than 32 amps; Common faults and solutions: 1. Check whether the power supply is powered on normally. The power display will light up to show the temperature. 2. In the case of normal power supply, the water flow opens, press the open key, the machine starts heating, the water heater displays: Water temperature 3. If the temperature does not rise, there are two possibilities: one is that the temperature control switch (overheat protection switch) inside the water heater jumps and can be restored by pressing the temperature control switch; the other is that the heating tube is faulty and the heat pipe can be replaced 4. If the display does not heat, the display lamp runs in circles, indicating that the water flow has not passed through the water heater,or the water pressure is too low, or the installation direction is wrong, pay attention to the water inlet and outlet should be installed correctly, but if the water pressure is enough, the water flow is not heated, then check the water heater inlet turbine, there may be dirty things stuck turbine,causing the water heater to not start. 5. It is recommended that the length of the water outlet pipe of the water heater should not exceed 3 meters, if it is longer than the length of the water pipe,there may be a water pressure difference, and the water pressure is not enough to start. (If the water tower is used in rural areas, the height of the water tower should be higher than 10 meters, so that the water pressure reaches the starting value.) 6. The display shows E1 overtemperature, E3/E4 or temperature sensor fault, power off first, use cold water over the machine, and then use the power,pay attention to the water flow is not too small 7. If the heater tube is faulty, E2 is displayed. Replace the heater tube Note: 1. Vertical installaton only. Horizontal installation is not allowed,in order to avoid dry heating 2. Please allow a slight dimension difference due to different manual measurements. 3. Due to the light and screen setting difference, the item's color may be slightly different from the pictures. 4. Wish you a wonderful on-line shopping! Please note: Vertical installation only, horizontal installation not allowed to avoid drying and heating