Launch X431 CR3001 Support Full OBDII/EOBD function Creader 3001 diagnostic tool Multilingual code reader scanner PK CR319 OM123

Many Customers has the doubt for the time 2019 in the back of CR3001 , pls note , it is the Copyright time , not manufactory time !!! If you care about it , pls do not make the order , thank you !

English, French, German, Spanish, Russian, Italian, Polish

1. LAUNCH Creader 3001 obd2 scanner Supports O2 Sensor test , EVAP system test, On-Board monitor test, While AD310 and AL319 DOES NOT ! 2. LAUNCH CR3001 Add more car models , including cars, SUVs,minivans,light-duty trucks all over the world. But the year supported may vary on different car makes and models.

Reading Codes:Show the detailed description of the Diagnostic Trouble Code (DTCs) Erasing Codes & Reset:Turns off Check Engine Light (MIL), clears codes and resets monitors. Data Stream:Reads and displays live ECU/PCM data stream, plotting functions graphically and stores freeze frame data. I/M Readiness Status:Shows whether the various emissions-related systems on the vehicle are operating properly and are ready for inspection and maintenance testing. Read Live Data Stream:Show the information of continuous data stream from a vehicle in live graphic (waveform) display. View Freeze Frame Data:Check the certain vehicle conditions which are recorded by the on-board computer at the time the emission-related fault occurs. O2 Sensor Test:Allows retrieval and viewing of O2 sensor monitor test results for the most recently performed tests from the vehicle’s on-board computer. On-Board Monitor Test:Retrieves and displays test results for emission-related powertrain components and systems. Read Vehicle Information:Display the information such as VIN (Vehicle Identification Number), CID (Calibration ID) and CVN (Calibration verification number), etc. Component Test:Certain vehicle components can be actuated by commands sent from the scanner to test their operability

Parts might cause your check engine light on include: 1. Gas Cap 2. Oxygen Sensor 3. Air Fuel Ratio Sensor 4. Mass Air Flow Sensor 5. Ignition Coils 6. Spark Plug Wires 7. Spark Plugs 8. Thermostat 9. EGR Valve 10. Evaporatative Emission Canister Purge Valve(EVAP) 11. Catalytic Converter. If the engine light is not turned off in time it will Cause Serious environmental pollution , Increased fuel consumption,Increased engine noise.Increased in temperature , ect

After entering the I/M Readiness, there will be 10 results on the list. Misfire monitor, fuel system, componentmonitor, catalyst monitor, heated catalyst, EVAP system, secondary air sys, 02 sensor, O2 sensor heater EGRand/or WVT. There will be an OK if each of them works fine. [Not all vehicles have these 10 parts]

LAUNCH CR3001 Screen Display