Freestyle Libre Sensor Armband for Protecting your Sensor. The alternative to Patches or Stickers. Many Colours with Black Strap.

Made in the UK.

The armband can be adjusted with the two attached buckles. I recommend that you adjust the armband to the correct tightness on your arm below where the sensor is attached then lift the holder and place it over the sensor. To remove the armband I would press down on the sensor and gently lift the holder off and move the armband down your arm.

30cm strap = 12 inch

40cm strap = 16 inch

50cm strap = 19 inch

There are now three options for the strap size and the strap can be adjusted for a smaller diameter arm. To find the length you need measure the circumference of your arm. If you don't have a fabric measuring tape then you can wrap a piece of string around your arm mark it and measure that. The length of elastic matches the maximum circumference of the arm. For example for a 35cm arm the 40cm strap would be needed. If you find you have a lot of excess strap after you have adjusted it you can cut the excess off and seal the edge with flame.

This armband is available in multiple colour options. The strap and buckles are black and the holder can be Red,Blue,Grey,Black, or White. Please see my other listings for a other colour options.

You will receive all the parts in picture 2. The Freestyle Libre sensor is not included.

The elastic arm strap may contain latex.

Please check my store for other colours and Freestyle Libre Armbands.

3D Printing works by laying down layers of plastic and therefore the surface finish will not be smooth like mass manufactured plastic parts and may have some visual artifacts. My pictures are always representative of the quality of finish you will receive.