Res-iT Epoxy Resin - Crystal Clear Epoxy Resin Kit with Hardener for Jewellery, Arts & Crafts, Wood Casting, Countertops

Res-iT Epoxy Resin 

(Mix Ratio = 1 to 1)

*NOTE*: Each Kit comes in a 50/50 split;

240ml kit = 120ml part A and 120ml part B

480ml kit = 240ml part A and 240ml part B

1L kit = 500ml part A and 500ml part B

2L kit = 1L part A and 1L part B

4L kit = 2L part A and 2L part B

Res-iT Clear Epoxy resin is premium quality epoxy resin for all your projects needs. Our ingenious product formulation and proven techniques will get you results that you can be proud of...

Features & Advantages of using our Resin Epoxy:

-Mirror-like Crystal clear finish

-High-grade UV Resistant

-Integrate Colour with ease

-FDA Grade

-Advanced Formula for Strength and Durability

-100% VOC Free and Odourless

-Self Levelling and Zero shrinking

Directions of Use:

*To Avoid bubbles please use a heat gun! and also make sure part A of the resin is slightly warm before use to avoid cloudiness*

1. Please use gloves when using Resin with any of your projects, and for longer periods of time ensure to wear a mask.

2. The ideal working temperature is 21-29C, Best results can be obtained in a dry, dust free environment, and also try to work on a flat, levelled surface.

3. The material must be mixed for at least 3 minutes, be careful not to whip excessive air into the mixture and for larger mixing quantities be sure to use a power mixer, for smaller quantities use stir sticks. Once mixed, pour into a clear container and mix for an additional 1 minute.

4. Pour the mixed resin onto the surface and distribute evenly, continue to pour to achieve the desired thickness, allowing the resin to flow evenly over the projects sides. Resin can be poured up to 1/4 inch per pour.

5. Use a heat source such as a heat gun to remove any bubbles by adding a small amount of heat to the surrounding area, the bubbles will rise to the surface and pop.

6. If you are going to make a second pour, the first pour will still be slightly sticky, after the second pour bubble may need to be removed again using the same technique mentioned. Material will feel hard after 45-60 minutes, cure to the point of workability is 24 hours, but full cure and maximum hardness can take up to 7 days depending on the temperature.

Technical Data Sheet:

Appearance = Liquid

Colour = Transparent

Density (g/m3) = Part A: 1.08+0.05, Part B: 0.96+0.03

Viscosity at 25 (mpa.s) = Part A: 1800+200, Part B:280

Mixed Viscosity at 25 = 550+50 mpa.s

Test by Brookfield DV2TRV at 25C = Max mixed viscosity is 800mpa.s

Mix Ratio = 1 to 1 by volume and weight

Gel Time = 30-40 minutes + 15 minutes at 25C for 100g

Curing Time = 8-10 hours at 25C, 6-8 hours at 35C, 24 hours completely dry

Demould time = 10-12 hours

Max Pour Depth = Best for step casting deep pours, 1-3cm max per single pour

Shelf life = 12 months